3D Printer AD597 K -type Thermocouple Temperature Control Interface Board
especially with a 3Pin 70cm connection for easy connection to the ramps1.4 use .
3D Printer AD597 K -type Thermocouple Temperature Control Interface Board
Advantages:
1 , each one will do functional testing.
2 , especially with a 3Pin 70cm connection for easy connection to the ramps1.4 use .
3 , the official wiki design a diode D1 ( to prevent reverse power ) , resulting in a pressure differential between the two sides of the ground , so that the thermocouple output signal Sg, to the motherboard rear end becomes Sg + Vs, so will lead to temperature allowed, our version using 0 ohm resistor in place of the diode temperature measurement more accurate.
Special note:
1 , the official version is not fully consistent , revised official version of the differential problem , with 0 ohm resistor instead of a diode D1 .
2 , due to low production , small welding difficulty , using manual welding.
Suitable for : ramps1.4 and Ultimaker , etc. can be used.
| Brands | 1.75mm |
|---|
Write Your Own Review
Sign In
Create New Account